Building the C-Bot 3D printer: Part 22 : Final wiring, near final bot

Jump to C-Bot blog index to see all the posts.


Over Fri, Sat & Sun I probably spent close to 14 hours doing the final wiring:  So much measuring, cutting, splicing, heat-shrinking, wire-routing, etc.  But man it’s pretty thing when complete.  And it even turned on when I plugged it in :)

Below are a few pics:  I still need to make a tray for the power supply, print a case for the LCD, and finish up the dual filament coolers (when the fans show up), but for the most part it’s complete, and ready for tuning!


Jump to C-Bot blog index to see all the posts.

Building the C-Bot 3D printer: Part 21 : Software Day 4: PID Autotune & start/end G-Code
Building the C-Bot 3D printer: Part 23 : Filament Cooling Fans
Comment are closed.