Building the C-Bot 3D printer: Part 16 : Assembly Updates

Jump to C-Bot blog index to see all the posts.


While I struggle with getting my Z-steppers to work, I did some frame upgrades:

  • I hadn’t ordered enough of the OpenBuilds ‘Black Angle Corner Connectors‘ : I needed 18, I bought 8 (not sure how I missed that)…  Mason needed extras as well, so he placed a big order, and I got my ten in today.  So, I swapped out my printed corners on both the bottom of the frame, and the parallel arms under the HPB with the new corners.  Metal FTW!
  • The 8x 55mm M5 bolts that held the wheels onto the Z-gantry weren’t long enough:  I couldn’t actually got a nut on the back-side.  Mason experienced the same issue, and picked up two 10-packs of 60mm M5 bolts and gave me one:  I went through the process, one at a time, of removing those bolts from the wheel assembly on the HPB, and swapping it for the new 60mm version, with a locknut on the end.  I held all the existing spacers, wheels, and shims in place (so they wouldn’t fall all over the floor when I removed the bolt) with tape on the bottom:  Worked great!

Thoughts on my Z-stepper issue:

  • The A4988 drivers (that came with my Rumba ) ‘continuous current per phase’ is 1A (see link).  The DRV8825‘s (like what Mason uses) are 1.5A.  I’m wondering if that 50% boost would be enough to lift the z-stage?  I found a 5-pack on Ebay for $13, so those are on order.  But it can take up to a month:  Mason may have a spare, and if so, I can test this out and see if the extra power is worth it.
  • I spent a good amount of time making sure my rear Z-extrusions were the exact width apart, and futzing with the HPB Z-stage brackets:  I can now lift the gantry with one hand with little resistance.  I also made sure the Z-steppers were exactly below the ACME lead-screw holders:  I can now get the HPB to lower, just not raise (without help from my hand).  So again, I hope the DRV8825’s will resolve this lifting issue.

Time tonight:  About 2 hours.


Jump to C-Bot blog index to see all the posts.

Building the C-Bot 3D printer: Part 15 : Software Day 1
Building the C-Bot 3D printer: Part 17 : Electronic & Software day 2
Comment are closed.