New 3D Print: Millennium Falcon

Decided to print (nearly) a whole roll of MakerGeeks Gray Matter Gray PLA on a cool Millennium Falcon model I found on Thingiverse.

Took 17h30m on my C-Bot, using a .6mm E3d-v6 Volcano nozzle, 450 micron, 60mm\sec @ 230 deg:

falcon

It’s pretty big.  Check out the timelapse here:  17 hours in 17 seconds:

New Commission: Denali
Building the C-Bot 3d Printer : Part 36 : Adding an inductive z-probe to RepRap Firmware / RADDS
  • Trackback are closed
  • Comments (1)
  1. Love my C-bot. Nice print!

Comment are closed.